Watts PWSSTD Manuale Utente

Installation, Operation and Maintenance ManualSeries PWSSTDWater Softener SystemsIOM-WQ-PWSSTDImportantPlease read the entire manual before proceedin

102367541112131BY PASS & YOKE IN INSTALLATION KITItem #5 is to be cut to .5" (12.5mm) above top of tank- .63" (16.1mm) below top of ta

11

IOM-WQ-PWSSTD 1225 EDP# 2915885 © 2012 WattsUSA: Tel. (800) 224-1299 • www.watts.com Canada: Tel. (888) 208-8927 • www.watts.caA Watts Water Tech

2READ Instructions Before Using• Before beginning installation, read these instructions completely. Then obtain all the materials and tools needed fo

3Softener Anatomy12374589Item # DescrIptIon1 Valve2 By-pass3 Resin Tank4 Distributor5 ResinNot Shown Brine Valve Assembly7 Salt Tank Lid 8 Salt Tank9

4SpecificationsFeed water ! Do not use this system on water that is microbiologically un-safe or of unknown quality without adequate disinfection befo

5Installation 1. Turn off gas or electric supply to the water heater.2. Turn off the water supply to pipes to be cut and drain the house water pipe

6Installation continued 14. Fully open two (2) cold (soft) water faucets near the water soft-ener.15. Fully open the house main water shutoff valv

7Softener OperationAs water enters the softener, it passes over a resin bed in the mineral tank. The resin consists of tiny beads of plastic called st

8Service continuedCleaning the Injectors and Screens 1) Turn off water supply to conditioner: a) If the conditioner installation has a “three

9problem cause solutIon1. Softener Fails To Regenerate. A. Electrical Service to Unit has been Interrupted. A. Assure Permanent Electrical Service (C